
It doesn’t look like Brunswick will get expanded quiet zone status near rail crossings downtown, not without spending several hundred thousand dollars.
The town’s 2012 application for expanded quiet zone status for the Union and Stanwood street crossings had been rejected by the Federal Railroad Administration.
TEC Associates recently reviewed the denied application, and concluded that the Union and Stanwood crossings won’t qualify for quiet zone status based on the amount of train traffic through the area unless socalled
“Supplementary Safety Measures” are put in place, according to a memo from Public Works Director John Foster.
One measure includes quad gates at each crossing, adding two more gate arm installations to completely block off both sides of the crossings.
“I have only done a couple of preliminary inquiries on the cost to upgrade to quad gates, but the numbers I have heard so far range from $100,000 to $300,000 per crossing so this does not appear to be financially possible,” Foster wrote in his memo. “Nate Moulton, MaineDOT, advised me (that) to his knowledge there are no quad gates in the state.”
Another measure includes a 60-foot-long center median island on either side of the rail crossing and the prohibition of any public road or commercial driveway within length of the island.
Alterations would also have to be made to roadside curbing, though “the impact on the abutting properties is quite negative,” said Foster.
The cost of the curb islands and roadside curbing is estimated at $40,000, according to Foster.
“At this point, construction of such a full SSM does not appear feasible,” Foster wrote.
Council Chairman Benet Pols on Friday said quiet zone designations for either Union or Stanwood street crossings would be a “pretty tough sell.”
“That’s not just because of the cost, which is substantial, but of the impact to long-standing businesses,” Pols said. “There have been busy enterprises in both places for a good, long time.”
Quiet zones have already been established for Park Row and Maine Street crossings.
Quiet zones maintain warning lights and crossing gates but restrict train horn blasts to limited daylight hours except in emergencies.
The FRA uses a risk index calculator that takes into account factors such as the rail crossing’s gates system, the amount of trains traveling through the area, and how automobile traffic is directed. If the the risk index is too high, the quiet zone designation is not granted.
One of the factors in applying for the quiet zone designation is the difficulty in calculating the number of trips made by Maine Eastern Railroad that operates between Brunswick and Rockland. Pan Am calculated a higher number of trips by Maine Eastern than the town, said Foster, and FRA determined that Brunswick exceeded the threshold to qualify for an expanded quiet zone.
The town council again began looking into expanding its quiet zone status in May last month after a Bodwell Street resident complained about continued disruptions from train horns.
QUIET ZONES maintain warning lights and crossing gates but restrict train horn blasts to limited daylight hours except in emergencies.
Comments are not available on this story. Read more about why we allow commenting on some stories and not on others.
We believe it's important to offer commenting on certain stories as a benefit to our readers. At its best, our comments sections can be a productive platform for readers to engage with our journalism, offer thoughts on coverage and issues, and drive conversation in a respectful, solutions-based way. It's a form of open discourse that can be useful to our community, public officials, journalists and others.
We do not enable comments on everything — exceptions include most crime stories, and coverage involving personal tragedy or sensitive issues that invite personal attacks instead of thoughtful discussion.
You can read more here about our commenting policy and terms of use. More information is also found on our FAQs.
Show less