
Residential customers will be hit twice, because businesses will very likely pass on their increased costs to their customers. Then, when the standard offer, currently 7.56 cents per kilowatt hour for electricty only — the transmission and distribution charge is separate — is reset in March, residential customers will be hit with their own price increases.
This is hardest on low income families and people on a fixed income, as well as those who use more electricity than the average customer. A business that is energy intensive, such as a sawmill or bakery, for instance, will feel a bigger hit than a customer whose electricity uses tend to be mostly lighting, for instance.
The standard offer for businesses will soar from 6.2 cents per kilowatt hour in October to 14.9 percent in January, a 42 percent increase.
In some aspects, businesses will be able to offset their own costs … lighting is an obvious example. Replacing incandescent lighting with compact fluorescents, or with LED lighting, can minimize the cost spikes. But not all costs are as easily managed.
Some of the cost increase is simple supply issues. Maine is heavily dependent on natural gas to run its power plants, and natural gas pipelines from fields in Pennsylvania where the gas is “fracked” from the ground do not move enough gas, especially in the winter months when demand is greater.
Maine lost its largest energy supplier when Maine Yankee closed. At its peak, Maine Yankee produced 60 percent of the state’s electricity, followed by natural gas combustion, hydro, biomass, and oil. Maine’s only coal plant closed down prior to Maine Yankee, and its only oil plant, Wyman Station on Cousins Island, was on the market for more than a year when its owner pulled it in August. Thus, if Maine were dependent only on Maine energy producers, we would be tied to the fluctuating natural gas prices, which haven’t been kind in recent years. In reality, the energy marketplace, known as ISONew England, purchases power from the least expensive sources available, and this year, has encouraged oil plants to make sure there is adequate supply on hand so that reliabiity is less of an issue.
Efficiency Maine says that there are programs that can help both businesses and residential customers keep their own costs down to some extent. They are offering rebates for heating options such as pellet stoves and boilers, heat pumps, woodstoves and geothermal systems, as well as heat pump hot water systems. They also offer rebates for air sealing work, insulation, and other efficiency steps for residential customers. There are options for businesses as well, extending beyond energy efficient lighting — which Efficiency Maine used to focus on — and for both businesses and residential customers there are energy loans that allow customers to do more with solar, small wind, fixing minor problems that prevent moving forward with grid-tied alternatives, and more.
On the Efficiency Maine website is an online calculator that demonstrates the variation in heating costs and hot water costs per household, based on method and price of energy. Geothermal energy is, at the current electricity rate, most energy efficient for heating, while solar energy with an electrical backup is most efficient for hot water heating. Unfortunately, there are no solar rebates now, even though they are the most efficient source for domestic hot water. There are heat pump hot water heaters, which according to the table, would cost $394 per year now. When the standard offer increases in March, as it is expected to do, the cost to run the heat pump will also increase. If the standard offer price rises by a mere 2 cents per kilowatt hour, the cost to run the heat pump water heater will jump from $394 per year to $451, still much lower than the average cost to run an electric water heater, $645. A solar domestic hot water system, which doesn’t qualify for a rebate but can be part of an Efficiency Maine loan, would cost $187 per year under the same scenario.
It is important to look at the systems that Efficiency Maine will provide incentives for, and find local people to install your system if necessary. While a heat pump hot water tank can be installed yourself for the rebate, most other systems, insulation, and air sealing that qualify for the rebate require professional installation.
Natural gas appliances will soon qualify for incentives as well, for both businesses and residences, after review by the Public Utilities Commission. High efficiency heating and hot water boilers, and commercial cooking equipment, are two examples of things that will be covered.
All of these things can be viewed at EfficiencyMaine.com, which also offers tips on how to improve your own home’s efficiency using some basic and easy techniques. Many projects, such as caulking, weatherstripping, and so on, can be do-it-yourself projects. Others may require an assessment and help from a professional to be sure the work is done correctly and you are getting what you are hoping to get out of the work.
Now, however, is the time to get the work done in order to save money through what promises to be a long, cold winter.
Comments are not available on this story. Read more about why we allow commenting on some stories and not on others.
We believe it's important to offer commenting on certain stories as a benefit to our readers. At its best, our comments sections can be a productive platform for readers to engage with our journalism, offer thoughts on coverage and issues, and drive conversation in a respectful, solutions-based way. It's a form of open discourse that can be useful to our community, public officials, journalists and others.
We do not enable comments on everything — exceptions include most crime stories, and coverage involving personal tragedy or sensitive issues that invite personal attacks instead of thoughtful discussion.
You can read more here about our commenting policy and terms of use. More information is also found on our FAQs.
Show less