2 min read

BRUNSWICK

Brunswick Public Works Director John Foster said that a temporary fix to a culvert under River Road that failed in August will be sufficient until a permanent replacement is installed next summer.

Public works will be meeting with representatives of the Army Corps of Engineers next week to discuss the culvert.

Heavy rains and flooding Aug. 13-14 resulted in damage to roads that suffered washouts, including River Road. In September, the town council approved $200,000 to repair the damage as part of an overall $1 million in spending on town roads.

At the time, Foster expected the River Road washout repairs to cost about $53,000.

Advertisement

So far, about $10,000 has been spent so far on the River Road culvert temporary fix.

Part of the River Road culvert, which had already rusted out, was temporarily patched with a 5-foot diameter culvert, “spliced” inside the remnants of the existing 6-foot culvert. That fix was installed within 24 hours of the washout, said Foster.

Public works had been planning on installing a new, permanent replacement culvert last month when they learned they would need a special Army Corps of Engineers permit.

That permit is needed, Foster said, because the stream that flows through the culvert leads to the Androscoggin River, which has been identified as critical salmon habitat, said Foster.

The town will likely apply for the permit this winter, Foster said.

The town wouldn’t be able to use a round culvert, such as the one it is replacing. Army Corps requires the culvert is designed to allow fish to pass through easier.

Advertisement

“We have to comply with their (the Army Corps’s) procedure,” said Foster. “They want fish passage to be addressed, and round culverts aren’t well suited to that.”

A flat-bottomed replacement culvert will likely be used, the exact design of which has yet to be determined. The culvert would be installed between mid-July and late September, in accordance with the Army Corps.

About two weeks ago public works was able to install a 5-foot diameter overflow pipe in an area above the existing culvert. That pipe is above the stream and will only channel water when there’s substantial rainfall.

“We’re confident the action taken will keep the road and the public safe in case of a significant rain event,” Foster said. “We think we’re good.”

The overflow pipe will be removed and saved for reuse once the new culvert is installed, said Foster.

jswinconeck@timesrecord.com



Comments are not available on this story. Read more about why we allow commenting on some stories and not on others.